|
 photo contest! |
ordering |
contact us |
Feeney Architectural Products |
Feeney Gateway |
Return Customer Log-In |
|
|
Customize Your Railing - DesignRail® Aluminum Posts
|
|
Posts are made from heavy duty 2-3/8" square tube extrusions and
come pre-cut to meet minimum railing height standards for
residential (minimum 36" & 38" high) or commercial (minimum 42" high).
Posts also come pre-drilled for cables when using horizontal cable
infill (except stair and ramp posts which must be field-drilled). Square posts can be fascia mounted,
fascia bracket mounted, surface mounted, or stanchion mounted.
|
|
We also offer a 45° corner post which allows single post construction at 45° corners.
As with the square posts above, these extrusions come pre-cut and pre-drilled (except when used on stairs and ramps). They can be either
surface mounted using a pre-attached standard 45° profile base plate, fascia mounted, or stanchion mounted. |
Fascia Mount
For side mounting to fascia boards, joists or walls.
Fascia Mount posts come with pre-drilled bolt holes.
|
Surface Mount
For top mounting to deck, patio or stair tread surfaces.
(5" square base plates come pre-attached).
|
|
|
Fascia Bracket Mount
For side mounting to fascia or rim joists when decking or nosing trim extends beyond the edge of the fascia board.
Posts are attached using metal brackets that are available with a 1-1/4" stand-off. Railing must have a bottom rail when using this mounting method. |
Stanchion Mount
For mounting on stone or tile covered concrete slabs or on roof decks where penetration
of waterproof roofing membranes must be minimized. Short stanchions are attached to the
structural members prior to pouring the slab or laying the roof membrane. Railing posts
are then sleeved over the protruding stanchion ends and secured with screws.
|
|
|
|
|
